24 small things was done in 2 weekend days Radar installed    Mast Check mast longitudinal angle. Portside lower shrouds - fix pin on spreaders root. during stepping mast up pin holding lowers on port side slide out of the intended position. I had to easy lowers and push it back to place. Install VHF antenna and test SWR - (Measured SWR 1.3). Just put antenna back to place. Install radar to the mast. Simple, but it the bracket appeared slightly deformed and rear holes ended up not aligned and i had to drill them out to provide some gaps and be able to put bolts in. Other challenge - lift Radar to the mast safely, but it is round and has no features to tie rope to it ;-) Install ring camera to radar mount. Drilled 3 holes and riveted mounting plate for Ring camera to be able to observe what is going on on the docks, especially when really bad weather hits. Put mainsail and sail pack back to the boat. Just put them back and connected the pack lazy jack back up to the m...

 Shower Thermostatic valve installed. Button is to ope/close shower, and regulator is supposed to control water temperature. so far water is running and not leaking. Short glance under sink. Connection hoses have synthetic cover, hopefully will not disintegrate fast.     Fixed windows last touches. Painted frames inside in black to mach with silicon.  V-berth. Last touch here too. Rebuilt triangle insert and made a pillow for it. Put hinges on the bottom locker at cabinet and found the locker opening may play as step for V berth. BUT, it will be nice to make a step sliding out when door opened.  Head Added handles to head door, For now they are mounted on VHB tape.  Door, View from inside Door, view from outside Replaced drawer stoppers. LPG solenoid controller, ready for installation.

 Day 206, New Fixed windows trim installation.   Interior (small things) Fixed windows  New trim around fixed windows made out of teak and installed. each trim piece made of 4 parts. all cut on my workshop CNC out of teak wood. Only thing left here - paint the gap between window and trim.    Other things done today Made and  installed Door-cover under the AC inlet. LPG sensor - alarm installed. I installed the alarm ind found it is alarming all time. I am pretty sure I have no LPG on the board.  I bought the sensor several years ago, and it was on the boat all the time and likely was "poisoned" by paint thinners fumes. Ordering a replacement. Other small things Replaced engine overheat dumb lamp fixture (original had rubber disintegrated) .   In attempt to tight engine (ignition) switch  I broke it, by break line it was cracked for a while.  Good to get it broken at the dock ;-)   Connected compass light back, added connector f...

Engine Replaced engine mounts with Ellebogen GT-SDD55 (#120450-06802)  recommended by Ellebogen sales representative.  https://ellebogen.com/us/ellebogen-gt-sdd55/ Originally I planned  to use  some hoist to lift engine, but problem on I34 there is companionway above the engine. the I think about carjack, but there not enough space to locate under engine to lift whole engine together and be able to level it.  Thanks forum. Some guy suggested to use basketball ball as lift bag. And it works absolutely well.     with $9 basketball ball pushed deflated  between carter and bilge floor 400 lb engine was lifted easy, even mode, unlike jacks ball provides you some freedom to move engine side to side.   Engine set back and tested. all works well.  New mounts in place.    Interior   Finished installation of back pillows for settees. Now we look much better  Special word about latches. Original latches was just f...